Assembly InstructionsModel 54230Butcher Block WorkCenter PLUSGENERAL:1. You have purchased model 54230. 2. Should you need assistance or need to repla
No pilot holes as softwood. 5/8” Pan Head ScrewsSTEP 9 A. Stick magnet to magnet plate on a door.B. With all other doors open, close the door. The mag
STEP 11 A. Upright unit.B. Determine if you want the Spice Rack on the left or right Side Panel. The Handle/Towel Bar will go on the other. Attach the
STEP 13 A. Tap 1” pins into the 4 sets of holes in the Back Panel. B. Just above the Bottom shelf on the inside of the Bottom Front Brace there are tw
STEP 15 A. Slide the Drawer into the front of the cart. Make sure the drawer moves freely, then retighten all bolts/nuts.B. Tap in the 5/8 wooden plug
For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai
Parts List Model 54230Drawer Bottom (1)P/N DBOT-54230Small Middle Shelf (2)P/N SMS-54230Center Shelf (1)P/N CS-54230Bottom Shelf (1)P/N BS-54230Left C
Hardware for 542301 3/4” Phillips Flat Head Bolt (8) 1 1/4” Phillips Flat Head #8 Screw (20) 7/8” Truss Head Machine Screw (8) 5/8” Pan Head Screw (8)
STEP 1A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should stick up about 1/2” when seated.STEP 2Take the 2
STEP 4 A. Attach the Drawer Back to the Drawer Sides with four 1 1/4” #8 screws. There are left and right sides. Make sure the slots that run the leng
WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste
STEP 5 A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the stick are posit
STEP 6 A. Lay Back Panel at on a smooth surface with holes up.B. Attach Side Panels with 1 3/4” machine screws (bolts) and hex nuts. After inserting
STEP 8 A. Install Doors by tting the pins in the top of the door into the holes in the Top Front Brace. B. Place washers on the pins on the bottom of
Comments to this Manuals