Catskill-craftsmen 54230 User Manual download pdf (Page 12)

STEP 13

A. Tap 1” pins into the 4 sets of holes in the Back

Panel. B. Just above the Bottom shelf on the inside

of the Bottom Front Brace there are two sets of holes.

Tap 1” pins into these holes.

C. On the Inside face of the Top Front Brace there is

a hole adjacent to each of the magnet blocks for the

outside doors. Tap one 1” pin into each hole.

D. Choose the height you want your middle

shelves, then tap the 2” pins in accordingly

on the Cabinet Dividers. For Side Panels,

use the metal shelf pins.

E. Slide the Cabinet Dividers between the

sets of pins in the Back Panel and the pins

in the Front Braces until dividers rest on

the Bottom Shelf. Make sure the edge

banding faces out.

NOTE: Eight 2” pins are provided in case

you want the center middle shelf & the

side middle shelves at different heights.

STEP 14

A. Invert Table Top on a smooth at

surface and make a large (X) mark over

each of the 4 pilot holes in the bottom.

Make marks about 1/2-1” long. These

marks will help you align the cabinet with

the pilot holes in the bottom of the Top.

B. Place the Cart Top on the cabinet. Open

the outside doors. Maneuver the Cart Top

so that the ( X ) marks/pilot holes in the

bottom of the Top align with the holes in

the “L” brackets. Secure top to “L” brackets

with 5/8” #7 screws.

1” Pins

Metal shelf pins

Edge banding toward front

Divider panel

in place

1 2 ... 7 8 9 10 11 12 13 14

No comments

Catskill-craftsmen 54230 User Manual Page 12