Catskill-craftsmen 64024 User Manual

Assembly InstructionsModel 64024The Deep Storage WorkCenterA. These units are Ready-to-Assemble. Catskill uses positive fastening methods such as wood

B. Take the back assembly and attach it to the side panels using three 1 1/4” #8 screws as above. Illustration 5A shows back panel assembly going into

C. Attach the drawer glides to the side panels using 1” #6 screws and round plastic spacers. See Illustration 5C to locate holes. See Illustration 5C

Illustration 6Attach 2 Butterfly Brackets on each Leg as illustratedusing 5/8” #8 ScrewsSTEP 6Final Cabinet AssemblyA. Invert top onto a smooth at su

B. With unit still upside down, tap the 4 caster sockets into the holes in the bottoms of the legs. Tap in the 4 casters by hitting straight down on t

Insert 1” pins at desired shelf heighttilt shelf to insert.Edge banding out.Groove in side shelf sits on top of pinsUnderside view of side shelf.C. Up

WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste

For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai

InsidePARTS 64024P/N: B-27/2/64024/BFBottom Front Brace (1)Inside ViewP/N: B-27/2/64024/TFTop Front Brace (1)P/N: DOOR-64024RRight Door (1)P/N: DOOR-6

Hardware 64024Caster Socket (4) P/N: SET SCREWBastion Set Screw (10)P/N: B-NUTBastion Barrel Nut (10)P/N: B-POSTBastion Post (10)5/8” Wooden Disk (12)

STEP 1Assemble DrawerA. Attach the drawer back to the drawer sides with four 1 1/4” #8 screws. There are left and right sides. Make sure the slots tha

STEP 2Attach Posts To LegsA. There are 2 right legs and 2 left legs. Diagonal legs are the same (Example: Right Front /Left Back). See Illustration 2

STEP 3Assemble Cabinet BackA. Take the Back Panel and the Back Legs, lay out as in illustration 3. The Back Panel cannot be installed improperly since

STEP 4Assemble Cabinet FrontA. Take the 2 Front Braces (Illustration 4) and tap/insert one 3/4” pin into each end of each brace. Take the 2 doors and

C. Invert the Front Cabinet Assembly. Attach the magnet plate to the inside top of the left door using a at head 1/2” #4 screw. Stick the magnet to t

STEP 5Attach Front Assembly to Back Assembly with Side PanelsA. This step is easier with 2 persons! Take the front assembly and attach the 2 side pane