Catskill Craftsmen 54220 Instruction Manual download pdf (Page 5)

STEP 3

Assemble Spice Rack

Insert retainer

rods into holes

Fasten Shelves with

1 1/4” Phillips Flat Head

#8 Screw (Bronze)

Pilot holes in shelves

go toward back

STEP 4

A. Attach the Drawer Back to the Drawer Sides with four 1 1/4” #8 screws. There are left and right

drawer sides. Make sure the slots that run the length of the Sides are aligned with the slot in the

Drawer Back to accept the Drawer Bottom.

B. Slide in Drawer Bottom, best side up, to inside of drawer.

C. Take the 2 bastion posts, align the threaded end of the posts with the post holes located near the

ends of the inside of the Drawer Front. Tighten posts down until the solid shaft of the posts hits the

wood. Back post out until the hole/screwdriver slot in end of post is parallel and in direct line with the

long edges of the Drawer Front.

D. Insert the barrel nuts into the nut access holes on the inside of the Drawer Sides with the threaded

ends of the nuts facing out. Take the Drawer Front and carefully insert the posts into the ends of

the Drawer Sides, through the sides of the nuts until seated. Push nut snug up against the wood in

the nut access hole toward the inside of Drawer Front. Hole should be slightly off-center toward the

Drawer Front. Insert the set screw and tighten down.

The ends of the sides should be tight against the inside

Drawer Front.

E. Attach the drawer handles with 1” Truss head

machine screws.

F. Attach the drawer glides

(left and right) to the Drawer

Sides using two 5/8” #5

screws per side. Wheels

go toward Drawer Back

and are up. The end

with no wheels

should touch the

Drawer Front.

1 1/4” #8

1” Truss Head Screw

5/8” #5

See next page to learn how the bastion fastening system works.

Also see our video on the Bastion Fastening System at www.catskillcraftsmen.com

1 2 3 4 5 6 7 8 9 10 ... 13 14

No comments

Catskill Craftsmen 54220 Instruction Manual Page 5