Catskill-craftsmen 43017 User Manual

CRAFTSMEN, INC.Assembly InstructionsModel 43017GENERAL:1. You have purchased model 43017. Overall dimensions of an assembled unit is 30 x 16 1/2x 34

STEP 11A. Stick magnet to magnet plate on right door.B. With left door open, close the right door. The magnet should be positioned over the wooden blo

STEP 13A. Insert and tap caster sockets withhammer until the teeth grab the wood.DONT POUND SOCKET FLATOR CASTER SHAFT WILLNOT ENTER.B. Insert caster

For continued beauty and long life ofyour Catskill Craftsmen cart, werecommend Catskill Craftsmens ButcherBlock Oil.If you would like to purchase But

WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 11. The Bastion fastening system

Side Panels (2)TOPTOPBack Panel (1)Not UsedDrawer Bottom (1)Drawer Dowel (1)Drawer Back (1)Middle Shelf (1)(has edge banding)Bottom Shelf (1)Drawer Si

1 3/4 Phillips Flat Head Machine Screw (8)1 1/4 Phillips Flat Head #8 Screw (12)7/8 Truss Head Machine Screw (8)5/8 #6 Pan Head Screw (4)1/2 Phil

1 1/4 Phillips Flat Head #8 Screw (12)4 Used in this step Attach a table top stick to thetop of each side panel using1 1/4 #8screws. The countersun

STEP 4A. Turn the side/back assembly ( from step 2 ) upside down ( invert ) on top of the inverted table top.B. Drop two 1 1/4 # 8 screws into the ho

STEP 51 1/4 Phillips Flat Head #8 Screw (4) 4 usedin this step7/8 Truss Head Machine Screw (8) 2 usedin this stepBarral Nuts (2) 2 usedin this st

STEP 6 Take drawer, insert the drawerdowel thru the hole in thedrawer back, invert drawerand place in cabinet cavity.Insert/turn drawer dowelinto the

STEP 8A. Take the top front brace ( with magnet block ), insert the pins in the braceends into the slots on the inside of the front legs and slide dow

STEP 9A. Tap/insert ONE 1 1/2 pin into each end of both doors. DONT OVERDRIVE PINS! Pins shouldstick up about 1/2 when seated.B. Attach the magnet