Assembly InstructionsModel 64026The Deep Storage WorkCenter with Contoured TopA. This unit is Ready-to-Assemble. Catskill uses positive fastening meth
B. Take the back assembly and attach it to the side panels using three 1 1/4” #8 screws as above. Illustration 5A shows back panel assembly going into
C. Attach the drawer glides to the side panels using 1” #6 screws and round plastic spacers. See Illustration 5C to locate holes. See Illustration 5C
STEP 6Final Cabinet AssemblyA. Invert top onto a smooth at surface. On Model 64024 there is no difference between the front and back of the Top, On M
B. With unit still upside down, tap the 4 caster sockets into the holes in the bottoms of the legs. Tap in the 4 casters by hitting straight down on t
C. Upright the unit and tap eight 1” 3/16 diameter steel pins into each leg. Place the side shelves on the pins. Groove sin the bottom of the shelves
WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste
For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai
InsidePARTS 64026P/N: B-27/2/64026/BFBottom Front Brace (1)Inside ViewP/N: B-27/2/64026/TFTop Front Brace (1)P/N: DOOR-64026RRight Door (1)P/N: DOOR-6
Hardware 64026Caster Socket (4) P/N: SET SCREWBastion Set Screw (10)P/N: B-NUTBastion Barrel Nut (10)P/N: B-POSTBastion Post (10)5/8” Wooden Disk (12)
STEP 1Assemble DrawerA. Attach the drawer back to the drawer sides with four 1 1/4” #8 screws. There are left and right sides. Make sure the slots tha
STEP 2Attach Posts To LegsA. There are 2 right legs and 2 left legs. Diagonal legs are the same (Example: Right Front /Left Back). See Illustration 2
STEP 3Assemble Cabinet BackA. Take the Back Panel and the Back Legs, lay out as in illustration 3. The Back Panel cannot be installed improperly since
STEP 4Assemble Cabinet FrontA. Take the 2 Front Braces (Illustration 4) and tap/insert one 3/4” pin into each end of each brace. Take the 2 doors and
C. Invert the Front Cabinet Assembly. Attach the magnet plate to the inside top of the left door using a at head 1/2” #4 screw. Stick the magnet to t
STEP 5Attach Front Assembly to Back Assembly with Side PanelsA. This step is easier with 2 persons! Take the front assembly and attach the 2 side pane
Comments to this Manuals