Catskill-craftsmen 64026 User Manual download pdf (Page 6)

STEP 3

Assemble Cabinet Back

A. Take the Back Panel and the Back Legs, lay out as in illustration 3. The Back Panel cannot be installed

improperly since the top and bottom hole measurements are the same distance top to bottom.

Nut Access Holes

Illustration 2

Illustration 2A

Inside View

Nut Access Holes

Illustration 2

Illustration 2A

Inside View

B. Drop a Barrel Nut, open

end up, into each of the

large nut access holes in

the Back Panel. There are

small indented marks on

the lip of the open end of

the Barrel Nut. This shows

the alignment of the holes

through the sides of the

Back Panel. Continue

seating Post until Post goes

thru the sides of the Barrel

Nut and the hole in the post

can be seen through the

threaded end of the nut.

When the back panel is ush

against the inside of the leg,

the hole in the post should

be offset toward the side of

the access hole adjacent

to the post. Insert the Set

Screw and tighten down

with Phillips screwdriver. Set

Screws should thread easily.

DO NOT CROSS THREAD

OR FORCE. As you tighten

the Set Screw down, the

tip of the screw will seek

the center of the hole in the

post, thereby pulling the side

of the Barrel Nut against the

inside edge of the access

hole and toward the leg. If

the nut is loose and does

not tighten down against the

wood after the Set Screw

is tightened then you will

need to remove the leg(s)

and tighten the Bastion Post

down another 1/2 turn, then

repeat above.

C. Attach Right Leg to Back

Panel in the same manner.

Illustration 3A shows the

assembled Back Panel.

Illustration 3

Illustration 3A

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Catskill-craftsmen 64026 User Manual Page 6

Comments to this Manuals

Related products and manuals for Furniture Catskill-craftsmen 64026