Catskill-craftsmen 1480DOR User Manual

Assembly InstructionsModel 1480DOREmpire IslandGENERAL:1. You have purchased model 1480DOR. 2. Should you need assistance or need to replace a damaged

Back Panel Assembly1/2” Phillips Flat Head #4 ScrewFront Panel Assembly1/2” Phillips Flat Head #4 ScrewSTEP 7 Attach Magnet PlatesUsing 1/2” Phillips

STEP 8Insert Caster Sleeves and Cutting Board GlidesA. Insert the Caster Sleeves into the holes in the bottom of the Legs and tap in with a hammer un

STEP 9Brace PrepA. Attach the Drawer Glides to the Glide Support Sticks using two 7/16” #6 screws. Slide top part of glide to expose pilot holes in

1 3/4 machine screws from back sideHex NutDrawer Glide SupportsIllustration 9DIllustration 9ETIP: Place a towel or tablecloth (movable) on the table,

STEP 10Attach Front Assembly 2 Person Job!! A. Attach the front assembly to the sides using Pins and 1 3/4” Machine Screws/Nuts.B. Insert the castors

Lay Top upside-down on at smooth surface and screw on the “L” brackets using 5/8” #6 at head screws as in illustration. Attach the “L” bracket to th

STEP 14Add Drawer and Cutting BoardsSlide the Drawer into the front of the cart then slide the Slide Out Cutting Boards into the sides of the cart. Dr

For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is

(1) Table Top-148044” x 26” x 1 1/4” (1) Bottom Shelf-148039 3/16” x 22 1/8” x 7/16”(1) Middle Shelf-1480DOR (Edge Banded)39 3/16” x 21 7/16” x 7/16”(

(2) Left Door-1480DOR22 1/4” x 16 5/8” x 3/4”(2) Right Door -1480DOR22 1/4” x 16 5/8” x 3/4’(1) Top Back Brace-1480DOR33 7/16” x 7 3/8” x 3/4”(2) Top

HARDWARE1 3/4” Phillips Flat Head Bolt (12) 1 1/4” Phillips Flat Head #8 Screw (12) 3/4” Long 3/16” DIA. Steel Pin (20)(Brace Ends and Glide Suports)

WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste

2 1/2” #8 Screws1 3/4” #8 Screwsglide holes toward the outside andoff center upCounter Sink UpCutting Board FrontTip: Dip screw tips in cooking oil to

STEP 3Drawer Assembly2 Drawer Sides, 1 Drawer Back, 1 Drawer Front, 1 Drawer BottomAttach Drawer Back to Drawer Sides using 1 1/4” #8 screws, then ins

Right LegLeft LegInside ViewBottomBottomSTEP 5 Leg PreparationInsert Bastion Posts into the 2 sets of Legs as illustrated.Tighten the Bastion down all

STEP 6 Front and BackPanel Assembly A. The Back Panel Assembly consists of a Right and Left Rear Legs, Top Back Brace, Bottom Brace, a Left Door and a